{"efta_number": "EFTA01088032", "page_count": 1, "url": "https://epstein-data.com/EFTA01088032", "pdf_url": "https://epstein-data.com/pdf/EFTA01088032.pdf", "pages": [{"efta_number": "EFTA01088032", "page_number": 0, "text_content": "Sawyers \nControl Systems Inc. \nMr. Richard Barnett \n9 East 71° Street \nNew York, NY \n=ace \nDear Richard: \n28 State Route 173 \nILImourn. NJ 08827 \nphone \nfax \nweb \nsawyerstontrols.com \nOctober 28, 2013 \nSawyers is pleased to present to you the following proposal for upgrading the current Digital Keypads and \nconvert over to a Biometric Entry system. This system design will be based upon a Fingerprint Reader that will be \ncustom enclosed in a single gang reader to replace the existing device within the same footprint. The Fingerprint \nReader will in turn be connected to an upgraded Software House Access Control processor. This would then \nupgrade the Reader, Processor and overall control of the door. Sawyers intends to re-use all of the door hardware, \nlocking mechanisms and egress devices. \nThis upgrade will probably require new wiring to the Fingerprint Door Station location. Sawyers has \nincluded line items for the re-wiring and labor associated with pulling additional cables. If this work is not required, \nit will not be invoiced. The custom plate for the reader will be fabricated to match the same finish as the door station \nthat was upgraded in 2009. We think the combination we are proposing will provide a very high level of security at \nthe doors while also looking attractive and passing any type of landmark inspections. \nPlease feel free to contact us with any questions or comments. \nTom Callahan \n9 East 71\" Biometric Entry System Upgrade: \nHolovision 520 Custom Fingerprint Reader \nEuro-NSW-Small (40 Fingerprint) Network Bio-Metric System \nInteractive Network Scanner Software for the Fingerprint Reader \nSoftware House CCure 9000 Site Server \nSoftware House iStar Edge 2 Door Controller (Can add 2 additional for future) \nSoftware House AS0063 Door Power Supply \nAdditional Reader Cables Run to the existing Digital Stations for Conversion \nLabor for installing and fishing the additional reader cables \n* If not required this will not be invoiced \nSawyers Labor to Install, Program, and Train on the new complete system \n$ 920 \n$ 1,085 \n$ 450 \n$ 1,250 \n$ 1,150 \n$ 450 \n$ 550 \n$ 750 \n$ 3,350 \nComplete System Total \n$ 9,955 \nEFTA01088032\n", "char_count": 2171}]}