From: Cecile de Jongh To: Jeffrey Epstein <[email protected]> Subject: 14: fiber project Date: Tuc, 08 Dec 2015 17:58:13 4.0000 Milne-Images: image001.jpg With warm regards. Cecile On Thursday. December 3.2015 7:19 PM. Hector Cintron wrote: When I left the office I asked Allan and I didn't see the cables. he will be looking into it. Also just an FYI I logged in the dragonwave to gather some information and I noticed that both Ethernet ports (data and management) on the LSJ side are plugged in to the switch creating a network loop . What I did was shutdown the management port on outside. This will help some but will be fixed tomorrow. I would not be surprised that accessing the internal is smoother now due to lowering of the packet drops and max times Pings before shuting down the port Success rate is 98 percent (9876/10063). round-trip madavgimax =1141128 ms After Success rate is 99 percent (9999/10000). round-trip madavgimax =114144 ms From: Jermame Rutin imailto Sent: Thursday. December 03.2015 17:21 To: Hector Cintron Cc: Omar Welch: Cecile de Jongh:Alyster Edwards Subject: Re: fiber project Email received from outside of the ATN domain. Use caution before using links/attachments. Hi Hector Terrence stated that the loge for dragonwaves are set to factory default . Regards Jruan Sent from my Phone On Dec 3. 2015. at 3:52 PM. Hector Cintron wrote: Hi Jermaine. I just spoke with omar and the cable hasn't arrived. what we can do is this. I'll split the work on two circuit is ready and I'll do the installation. I'll bring up the router and install the 2 switches to be able ViNGN is up. There will be a downtime of between 1 to 2 hours as I make the changes. If this is acceptable I'm a once this is done I can start with the verification of the link (no changes will be made). On the second trip I'll go to the island with Alyster takedown the dragonwave to do the following: Test ViNGN circuit Test ViNGN (allover Verify all ground