From: Richard Kahn c:I > To: Jeffrey Epstein [email protected]> Subject: Fwd: Scaffolding Date: Wed, 15 May 2013 14:48:41 ♦0000 Inline-Images: IMG_0140.JPG attached arc Ion thoughts on building scaffolding my cost estimate is as (OHMS: michael $400 per day (vs 300) ion $300 per day 3.5 days for install and take apart = 3.5 x 700 = 2,450 estimated material cost with delivery = 1,050 total cost 3,500 please advise if ok to proceed Richard Kahn HBRK Associates Inc. 575 Lexington Avenue, 4th Floor, Neilialork 10022 tel fax cell Begin forwarded message: From: ion nicola Date: May 14, 2013 9:00:52 PM EDT To: Richard Kahn •ffi Subject: RE: Scaffolding hi rich, i drew a sketch of a scaffolding (platform) can be built with wood as i told you, see attachment. i didnt draw all the verticals we need. in the between two verticals should be another one in the middle, so the total no of verticals (2by4) is 35. for horizontal we need like 23 pieces of 2by4. X we need 26 pieces of 2by4 so total of 2by4 would be around 90 pieces. these 2by4 comes 8, 10, or 12 feet long, and one piece is around $3, so the total would be like $300. then for the platform we need 12 pieces plywood 8x4ft, 2/3 inch thick, plus two more pieces of plywood to cut squares of plywood lx1 ft to put under the legs to protect the rug in the room. and one piece of plywood should be around $25. so total plywood would cost around $400 so probably all the materials would be around $800, and everything can be reused. the platform would be 16ftX24ft. the entire dinning room is 21ft X27ft but i dont need close to the wall because the crown molding is one and a half foot wide.. i told you about michael, to do that because he is engineer and he've done it before, .and said i can help him because i am engineer too, i studied poli technique 4 years before fine arts.. so there would be two engineers... :-) but any construction company could built this platform too, probably faster beca